投稿时期刊模板如何使用

SCI投稿信件模板 一、投稿信 1. Dear Dr. XXX I am sending a manuscript entitled “XXXX” by XXXX, which I should like to submit for possible publication in the journal of XXXX. Yours sincerely 2. Dear Dr. XXX Enclosed is a manuscript entitled “XXX” by XXX, which we are submitting for publication in the journal of XXX. We have chosen this journal because it deals with XXX. We believe that sth would be of interest to the journal’s readers.3. Dear Dr. XXX Please find enclosed for your review an original research article, “XXX” by sb. All authors have read and approve this version of the article, and due care has been taken to ensure the integrity of the work. No part of this paper has published or submitted elsewhere. No conflict of interest exits in the submission of this manuscript, and we have attached to this letter the signed letter granting us permission to use Figure 1 from another source. We appreciate your consideration of our manuscript, and we look forward to receiving comments from the reviewers. 二、询问有无收到稿件 Dear Editor, We dispatched our manuscript to your journal on 3 August 2006 but have not, as yet, receive acknowledgement of their safe arrival. We fear that may have been lost and should be grateful if you would let us know whether or not you have received them. If not, we will send our manuscript again. Thank you in advance for your help. 三、询问论文审查回音 Dear Editor, It is more than 12 weeks since I submitted our manuscript (No: ) for possible publication in your journal. I have not yet received a reply and am wondering whether you have reached a decision. I should appreciate your letting me know what you have decided as soon as possible. 四、关于论文的总体审查意见 1. This is a carefully done study and the findings are of considerable interest. A few minor revision are list below. 2. This is a well-written paper containing interesting results which merit publication. For the benefit of the reader, however, a number of points need clarifying and certain statements require further justification. There are given below. 3. Although these observation are interesting, they are rather limited and do not advance our knowledge of the subject sufficiently to warrant publication in PNAS. We suggest that the authors try submitting their findings to specialist journal such as XXX. 4. Although this paper is good, it would be ever better if some extra data were added. 5. This manuscript is not suitable for publication in the journal of – because the main observation it describe was reported 3 years ago in a reputable journal of XXX. 6. Please ask someone familiar with English language to help you rewrite this paper. As you will see, I have made some correction at the beginning of the paper where some syntax is not satisfactory. 7. We feel that this potentially interesting study has been marred by an inability to communicate the finding correctly in English and should like to suggest that the authors seek the advice of someone with a good knowledge of English, preferable native speaker. 8. The wording and style of some section, particularly those concerning HPLC, need careful editing. Attention should be paid to the wording of those parts of the Discussion of and Summary which have been underlined. 9. Preliminary experiments only have been done and with exception of that summarized in Table 2, none has been repeated. This is clearly unsatisfactory, particularly when there is so much variation between assays. 10. The condition of incubation are poorly defined. What is the temperature? Were antibody used? 五、给编辑的回信 1. In reply to the referee’s main criticism of paper, it is possible to say that XXX One minor point raised by the referee concerns of the extra composition of the reaction mixture in Figure 1. This has now been corrected. Further minor changes had been made on page 3, paragraph 1 (line 3-8) and 2 (line 6-11). These do not affect our interpretation of the result. 2. I have read the referee’s comments very carefully and conclude that the paper has been rejected on the sole grounds that it lake toxicity data. I admit that I did not include a toxicity table in my article although perhaps I should have done. This was for the sake of brevity rather than an error or omission. 3. Thank you for your letter of XXX and for the referee’s comments concerning our manuscript entitled “XXX”. We have studied their comments carefully and have made correction which we hope meet with their approval. 4. I enclosed a revised manuscript which includes a report of additional experiments done at the referee’s suggestion. You will see that our original findings are confirmed. 5. We are sending the revised manuscript according to the comments of the reviewers. Revised portion are underlined in red. 6. We found the referee’s comments most helpful and have revised the manuscript. 7. We are pleased to note the favorable comments of reviewers in their opening sentence. 8. Thank you for your letter. I am very pleased to learn that our manuscript is acceptable for publication in Cancer Research with minor revision. 9. We have therefore completed a further series of experiments, the result of which are summarized in Table 5. From this we conclude that intrinsic factor is not account. 10. We deleted the relevant passage since they are not essential to the contents of the paper. 11. I feel that the reviewer’s comments concerning Figures 1 and 2 results from a misinterpretation of the data. 12. We would have included a non-protein inhibitor in our system, as a control, if one had been available. 13. We prefer to retain the use of Table 4 for reasons that it should be clear from the new paragraph inserted at the end of the Results section.

针对当前大多数学术期刊对科技论文的普遍要求，介绍论文的主要排版格式如下。这些格式也是建立论文文档模板的基本样式参数。论文标题：黑体（中文）或Times New Roman（英文），小2号（18磅），居中，1.5倍行距，前后段落间距都是12磅，首行缩进0字符。一级小标题：黑体（中文）或Times New Roman（英文），小4号（12磅），左对齐，行距17磅，段落间距为段前，行、段后0.5行，首行缩进0字符。二级小标题：黑体（中文）或Times New Roman（英文），5号（10.5磅），左对齐，行距17磅，段落间距为段前0.5行、段后0.5行，首行缩进0字符。三级小标题：宋体（中文）或Times New Roman（英文），5号（10.5磅），左对齐，行距17磅，段落间距为段前0.25行、段后0行，首行缩进0字符。正文：宋体（中文）或Times New Roman（英文），5号（10.5磅），两端对齐，行距17磅，段落间距为段前0行、段后0行，首行缩进2字符，字距可加宽0.3磅左右。作者：宋体（中文）或Times New Roman（英文），小4号（12磅），居中，行距17磅，段落间距为段前0.5行、段后0.5行，首行缩进0字符，字距加宽0.3磅左右。作者单位：宋体（中文）或Times New Roman（英文），小5号（9磅），居中，行距17磅，段落间距为段前0.5行、段后0.5行，首行缩进0字符。字距加宽0.3磅左右。摘要：宋体（中文）或Times New Roman（英文），小5号（9磅），两端对齐，行距15磅，段落间距为段前0.25行、段后0.5行，首行缩进0字符，字距加宽0.3磅左右。参考文献：宋体（中文）或Times New Roman（英文），6号（7.5磅），两端对齐，行距15磅，段落间距为段前0.25行、段后0.5行，首行缩进0字符，自动编号。表题、图题：黑体（中文）或Times New Roman（英文），小5号（9磅），居中，行距15磅，段落间距为段前0.5行、段后0.25行，首行缩进0字符，字距加宽0.3磅左右。以上是论文中常用项目的格式，各期刊的排版要求可能会有所不同，但作为投稿，做到上述要求已经足够了。作者在实际工作中，应当参考上述要求先建立文档模板，然后应用此模板及其中的样式、格式，来编辑和排版自己的论文。在为段落设置字体或定制样式字体时，不能简单地只在工具栏的字体框内选择一个字体，而应当在格式菜单中点击“字体”选项，并在字体设置框中同时选择合适的中文字体和西文字体，此时还可以同时设置“字形”、“字号”、“字符间距”等属性。用这种专业设置的方式，可以同时满足中文和西文的要求。